OFS-HE3 + OFS-VS
Cutting center featuring horizontal contour cutting machine OFS-HE 3, height-adjustable take-off conveyor and vertical contour cutting machine OFS-VS
Cutting line for contours OFS-HE3 + OFS-VS
Utilization of the cutting line for pure mattress or furniture cuts as well as for 3D contours and technical parts
- High capacity and flexibility of the cutting centre as both contour cutting machines can process different jobs at the same time.
- Fully automatic sheet transport from the horizontal to the vertical contour cutting machine
- Consistently high cut quality with no manual intervention in the production process (unmanned)
- Both machines are linked to each other and are controlled by a superior software (POS)
- Automatic production of 3D parts in one process instead of time-consuming gluing
- System flexibly adapts to different space requirements – the machines can be arranged in a line or integrated in complete cutting lines
Key Facts
Application
Upholstery, mattresses, furniture, packaging and automotive industry as well as technical articlesContour cutting (horizontal knife)
Material
PUR soft foam, PUR HR foam, visco-elastic foam, latex, non-woven material, Basotect®
Cutting Tool
Precision-ground micro-toothed circulating knife 3 x 0.6 mm
Alignment station
- Inclinable belt with integrated air cushions
- For the lateral alignment of a rectangular block before it is processed at the horizontal contour cutting machine.
- A manual aligning of the block is not necessary anymore.
- Can also be used with visco-elastic foam
Loading and unloading conveyors
- Allow an automatic loading and unloading and thus a continuous production flow
- Positioning upstream or downstream of the machine, respectively
- With horizontal machines, the unloading conveyors can also be placed on the side.
- Prevention of idle times of the machine
POS (Production Order System)
- The machines can be incorporated into the POS (Production Order System) superior job management system by means of a corresponding software module and are hence part of a complete machine network.
Separator
- For the lateral aligning of one block as well as for the separation of two blocks upstream of the OFS-HE3
- For higher accuracies of the cutting result: the seperator creates a gap between two blocks which is then used by the automatic centre support of the OFS-HE3 as an additional support of the knife
Shuttle
- E. g. for the transport of the material between both contour cutting machines if they are positioned parallel to each other
- Automatic charging of machines replaces manual charging
- Individual traverse paths depending on application and space conditions